Arrow Gear Company Logo
Go to Engineering!
Go to Manufacturing!
Go to Heat Treating!
You are here!
Go to Total Quality Management!
Go to About Arrow!
Quality Control that assures on-the-job performance In accord with our production standards, Arrow quality control procedures meet or exceed the requirements outlined in MIL-Q-9858 and MIL-I-45208.
Our bevel gears are tested on Gleason equipment for tooth contact pattern, quietness of operation, pitch diameter concentricity, mounting distance and backlash. Tooth spacing equipment measures pitch variation as small as .0001 inch. Careful attention is given to the critical demands of assembly, with the gears matched into sets or to masters, and marked to show the mounting distance and backlash at which they best carry the operating loads at the lowest noise level.
Computer-assisted quality assurance procedures are followed and are enhanced by the use of up-to-date metrology measurement tools and instrumentation.

careful Attention to critical demands
 
Questions? Please complete our on-line information request form!

Your Authorized Arrow Gear Company Representative:

 
 Jerry J. Emerson

e-mail: je@jemerson.com
1312  1st Avenue NW
P.O. Box 1523
Cedar Rapids, IA 52406
(Ph) 319-365-1750  (Fax) 319-366-2251
1-800-568-4430

 
Back to Manufacturer's Representative.

 
Arrow Gear Company Logo